SorbentSystems.com

IMPAK CORPORATION

PAKVF3.5D

This lamination of film foil and polyethylene has a wide range of uses where a high barrier film is needed with a low WVTR. It is ideal for packaging of hygroscopic items and products susceptible to corrosion, and in food or medical device packaging, where very low oxygen levels are required.

NOTE: PAKVF3.5D is 3.5 mils thick and offers the appropriate barrier for food products. In some unique applications where an even stronger barrier is needed, we offer 5 mil thick PAKVF4C structure is 5.0 mils minimum also with an FDA approved sealant layer.

PHYSICAL PROPERTIES (48GaPET/ PE / .00035 FOIL / LDPE)



IMPAK CORPORATION makes no warranty, expressed or implied, as to the suitability of these materials for any specific use. The values shown above were developed from random samples taken from production material. We believe them to be typical for the product. Actual values may vary somewhat from those depicted here. Customers should determine product suitability based upon their own internal criteria.
Total Thickness (mils) 3.5 mil

Tensile Strength (ASTM D 882)LBS at break

MD: 17.0 lb.
XMD: 14.0 lb.
Bursting Strength (TAPPI T403) <70 psi.

Puncture Strength(FTMS 101-C Method 2065.1) <16 psi.

Heat Seal Strength (ASTM-D-882) 375F ; 26psi ; 1 sec 12 lb./in

Water Vapor Transmission Rate (FED. 101) 0.0003gr./100in² 24hrs.

Back to Main Page
©1999-20004 SorbentSystems.Com. All rights reserved.